BLOG main image
분류 전체보기 (781)
LENOVO (19)
HP (3)
DELL (7)
IBM (32)
My Retain Tip (697)
자료실 (0)
Firmware (5)
기타서버관련소식 (5)
IBM Server Picture (3)
STUDY (2)
설정세팅 (0)
Visitors up to today!
Today hit, Yesterday hit
daisy rss
tistory 티스토리 가입하기!
2013. 2. 28. 15:30
Notice!!
IBM
본 블로그의 모든내용은 ibm.com에 있는 내용이며 본 블로그의 내용은 증빙내용으로는 활용 불가능합니다
주의! 모든 방문자는 공지를 반드시 읽어본 후 글을 읽으시기 바랍니다.:*필독공지*

딴지 거실분들은 절대 읽지 마시고 100% 정확한 정보가 있는 ibm.com 에서 확인하시기 바랍니다.
RETAIN tip: H207307

 

 

 

 

리테인 참고

 

Symptom

The Intel X520 10 gigabit (Gb) Ethernet adapter's option ROM is disabled by default and therefore the adapter is not seen in UEFI and not available as a Preboot eXecution Environment (PXE) resource.

Affected configurations

The system is configured with one or more of the following IBM options:

  • Intel X520 Dual-Port 10GbE SFP+ Embedded Adapter for IBM System x, option 49Y7980, any CRU
  • Intel X520-DA2 Dual-Port 10 GbE SFP+ Adapter for IBM System x, option 49Y7960, any CRU

This tip is not system specific.
This tip is not software specific.

Workaround

The following steps will enable the option ROMs on the Intel adapters:

  1. Create the ISO for the Intel software to a CD.
  2. Open the Intel Software.
  3. Open the 'Start_UEFI_ISO' folder.

3.        Open the 'Start_UEFI_ISO' folder -> 3.        Open the 'Boot_UEFI_ISO' folder

   Shell>startutil64e.efi -all -FE -> Shell>bootutil64e.efi -all -FE ->
 
 

  1. Copy 'efi_boot_update.iso' to a Hard Disk Drive (HDD).
  2. Burn 'efi_boot_update.iso' to a CD.
  3. Insert the 'efi_boot_update' CD into the server with the Intel NICs.
  4. Start to the 'efi_boot_update' CD.
  5. Wait till the 'Shell>' prompt appears.
  6. At the 'Shell>' prompt enter:

      Shell>startutil64e.efi -all -FE
  7. Press Enter.
  8. After the procedure finishes, type 'exit.'
  9. Restart the server.
  10. Press F1 to enter UEFI.
  11. In UEFI, go to System Settings --> Network to see the adapters.

If the UEFI 'efi_boot_update' CD does not start, performing the following should allow the CD to start:

  1. Restore UEFI defaults.
  2. Load the CD and follow the instructions Product Engineering (PE) provided previously.
About
IBM 최신서버에 관련된 경험과 지식을 공유하는 블로그이며 블로그에 처음오신분은 *필독공지*를 꼭 먼저 읽어보시기 바랍니다.