Procedure
1. Restart the management node.
2. When the firmware splash screen is displayed, press F12. The setup menu is
displayed. The screen displays confirmation that F12 has been pressed.
3. Select Recovery partition.
4. When the boot options screen is displayed, select Full system recovery. After
approximately 30 to 45 minutes, the recovery process ends and the
Management Server Setup wizard opens.
Note: The system displays Loading Bootloader, but no additional messages are
displayed during the recovery process. If the screen saver is activated and the
screen goes blank during this stage, press the Shift key to deactivate the screen
saver.
5. Either complete the Management Server Setup wizard or restore a previous
configuration from a backup.
What to do next
Important: If your recovery partition is an earlier version of the management
software than the version before the recovery procedure, update the management
software to the same version as before the recovery operation after you complete
the Management Server Setup wizard. If you do not update the management
software in this situation, the management software is older than other
components in your environment, which might cause compatibility problems.
For more information about setting up the management node with the wizard, see
the configuration section in the IBM Flex System Manager Systems Management
Guide.
For more information about restoring a backup image, see the backup
https://www.ibm.com/support/knowledgecenter/en/HW94A/com.ibm.acc.8731.doc/dw1kp_book.pdf?view=kc
'My Retain Tip > Pure Flex' 카테고리의 다른 글
| FSM CONFIG BACKUP & RESTORE (0) | 2017.05.09 |
|---|---|
| FSM 디스크 고장시 교체 후 복구방법 (0) | 2017.05.09 |
| Flex System Manager 메모리 장착 순서 (0) | 2017.05.09 |
| List of Features on Demand for FSM (0) | 2017.05.09 |
| IBM Flex System Manager Recovery DVDs (0) | 2017.05.09 |