BLOG main image
분류 전체보기 (781)
LENOVO (19)
HP (3)
DELL (7)
IBM (32)
My Retain Tip (697)
자료실 (0)
Firmware (5)
기타서버관련소식 (5)
IBM Server Picture (3)
STUDY (2)
설정세팅 (0)
Visitors up to today!
Today hit, Yesterday hit
daisy rss
tistory 티스토리 가입하기!
2018. 5. 31. 00:33
Notice!!
IBM
본 블로그의 모든내용은 ibm.com에 있는 내용이며 본 블로그의 내용은 증빙내용으로는 활용 불가능합니다
주의! 모든 방문자는 공지를 반드시 읽어본 후 글을 읽으시기 바랍니다.:*필독공지*

딴지 거실분들은 절대 읽지 마시고 100% 정확한 정보가 있는 ibm.com 에서 확인하시기 바랍니다.
Table of ContentsView in Frames

Accessing the web UI

 

After you install OnCommand Insight, you must install your licenses and then set up Insight to monitor your environment. To do this, you use a web browser to access the Insight client (web UI).

Steps

  1. Do one of the following:
    • Open Insight on the Insight server:

      https://fqdn

    • Open Insight from any other location:

      https://fqdn:port

      The port number is either 443 or another port configured when the Insight server was installed. The port number defaults to 443 if you do not specify it in the URL.

    The OnCommand Insight dialog box displays:
  2. Enter your user name and password and click Login.

    The following table shows the default user name and password. Change these defaults as soon as possible after installation:

    Data

    Value

    Default user name

    admin

    Default password

    admin123

    If the licenses have been installed, the data source setup page displays.
    Note: An Insight browser session that is inactive for 30 minutes is timed out and you are logged out of the system.

 

About
IBM 최신서버에 관련된 경험과 지식을 공유하는 블로그이며 블로그에 처음오신분은 *필독공지*를 꼭 먼저 읽어보시기 바랍니다.