49Y7960,49Y7980 NIC 10GbE 인식오류

RETAIN tip: H207307

 

 

 

 

리테인 참고

 

Symptom

The Intel X520 10 gigabit (Gb) Ethernet adapter's option ROM is disabled by default and therefore the adapter is not seen in UEFI and not available as a Preboot eXecution Environment (PXE) resource.

Affected configurations

The system is configured with one or more of the following IBM options:

• Intel X520 Dual-Port 10GbE SFP+ Embedded Adapter for IBM System x, option 49Y7980, any CRU
• Intel X520-DA2 Dual-Port 10 GbE SFP+ Adapter for IBM System x, option 49Y7960, any CRU

This tip is not system specific.
This tip is not software specific.

Workaround

The following steps will enable the option ROMs on the Intel adapters:

1. Create the ISO for the Intel software to a CD.
   
2. Open the Intel Software.
   
3. Open the 'Start_UEFI_ISO' folder.

3.        Open the 'Start_UEFI_ISO' folder -> 3.        Open the 'Boot_UEFI_ISO' folder

   Shell>startutil64e.efi -all -FE -> Shell>bootutil64e.efi -all -FE ->
 
 

1. Copy 'efi_boot_update.iso' to a Hard Disk Drive (HDD).
   
2. Burn 'efi_boot_update.iso' to a CD.
   
3. Insert the 'efi_boot_update' CD into the server with the Intel NICs.
   
4. Start to the 'efi_boot_update' CD.
   
5. Wait till the 'Shell>' prompt appears.
   
6. At the 'Shell>' prompt enter:
   
   

   Shell>startutil64e.efi -all -FE

7. Press Enter.
   
8. After the procedure finishes, type 'exit.'
   
9. Restart the server.
   
10. Press F1 to enter UEFI.
    
11. In UEFI, go to System Settings --> Network to see the adapters.
    

If the UEFI 'efi_boot_update' CD does not start, performing the following should allow the CD to start:

1. Restore UEFI defaults.
   
2. Load the CD and follow the instructions Product Engineering (PE) provided previously.