2011. 5. 17. 08:01
Use the following FW flash order:
1. IMM
2. reset IMM
3. re-connect to IMM
4. UEFI (system must be powered on)
5. FPGA (system must be powered on)
6. reset IMM
7. reconnect to IMM
8. reboot server
위 순서대로 하셔야 문제가 없습니다.
순번대로 차례대로 천천히 하시기 바랍니다.
The recommended way to update firmware is to use to use ToolsCenter UpdateXpress System
Pack Installer (UXSPI) or Bootable Media Creator (BoMC) (see section 2.3). If you choose to
update your firmware via individual packages, the preferred order to update the firmware is:
• Integrated Management Module (IMM)
• UEFI firmware
• FPGA firmware (if applicable to the system)
• Dynamic System Analysis (DSA) Preboot
'My Retain Tip > X Series' 카테고리의 다른 글
| Firmware Update Best Practices 펌웨어업데이트 가이드 (0) | 2011.05.19 |
|---|---|
| IBM X3650 연결 Controller accessories (0) | 2011.05.18 |
| X3650 M2 + MR10i + 12DISK 케이블 연결 (0) | 2011.05.16 |
| X3200M3 7328 메모리 연결순서 RDIMM UDIMM (0) | 2011.05.15 |
| IBM장비에 우분투 설치는 어떻게? (0) | 2011.05.13 |